Re: electric fuel pump to assist starting?
|
||||
---|---|---|---|---|
Forum Ambassador
|
Dave, I think you are correct about the dead-man switch. I don't run mine except to prime the carbs. I don't have an electric pump yet on the 400, but I am going to install one. If the 400 sits for more than a week, I have to crank it for a while to get enough gas to run it. I think I'd rather have the oil pressure of a running engine than the doubtful pressure of a cranking one. You say to-mah-toe, I
say toe-may-toe. I wouldn't want to run on the electric pump except in an emergency.
Posted on: 2010/4/15 15:08
|
|||
|
Re: electric fuel pump to assist starting?
|
||||
---|---|---|---|---|
Webmaster
|
I just bought the Airtex E8016S (12v, 2.5-4 psi) pump based on a recommendation from Randy. I believe he bought the E8012S which is a higher PSI, and then he used a regulator with it. I purchased it from RockAuto.com for about $50.
I'm showing the E8011 model that Mark used as being the only one in Airtex's lineup that is for a 6v application. It's rated at 5-8 PSI and is the same foot print, and style as the two pumps that Randy and I have.
Posted on: 2010/4/15 14:47
|
|||
-BigKev
1954 Packard Clipper Deluxe Touring Sedan -> Registry | Project Blog 1937 Packard 115-C Convertible Coupe -> Registry | Project Blog |
||||
|
Re: 32 Exhaust wrap
|
||||
---|---|---|---|---|
Home away from home
|
I did get an email from Joe the owner today. He indicated they were going to make a new muffler to the size I needed. He also said they were going to pay shipping both ways, but I responded that since the crossover tailpipe could have been correct, I would pick up shipping back to him. I thought that was fair. I also added that I hope he will ask 30s Packard owners which end they want the pipe to come out on new orders.
Anyway, I think I'm on my way to being fixed with expected delivery in about two weeks. My only beef with them was unanwered phone calls, but Joe does have an attitude that he wants you to be satisfied with their product which is good.
Posted on: 2010/4/15 14:30
|
|||
|
Re: electric fuel pump to assist starting?
|
||||
---|---|---|---|---|
Forum Ambassador
|
Though I have never had the need for anything other than the factory mechanical pump I can see why some folks want one, especially if they live in a hot climate or are prone to vapor lock. In my view they should be wired to a "dead-man" type switch which requires you to keep your finger on it if you're pushing thru the mechanical pump because more than one engine has been lost when the mechanical pump diaghram sprang a leak and you didn't know it so you keep blissfully driving along. Eventually enough gasoline may dump into the crankcase to dilute the oil, wipe out bearings etc., with an occasional underhood fire with horrible consequences. If you add an electric pump, just keep this in mind!
Posted on: 2010/4/15 13:34
|
|||
|
Re: electric fuel pump to assist starting?
|
||||
---|---|---|---|---|
Home away from home
|
Thank You to all who responded.
Will install tomorrow. John Miller
Posted on: 2010/4/15 13:16
|
|||
|
Re: electric fuel pump to assist starting?
|
||||
---|---|---|---|---|
Home away from home
|
Mark Lambert recommends the Airtex E-8011 available from CarQuest (and others). No pressure regulator needed. I use it with an on/off switch, to help in starting and for occasional use to eliminate on-the-road vapor locking.
Posted on: 2010/4/15 12:41
|
|||
West Peterson
1930 Packard Speedster Eight Runabout (boattail) 1940 Packard 1808 w/Factory Air 1947 Chrysler Town and Country sedan 1970 Camaro RS https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?topic_id=4307&forum=10 http://aaca.org/ |
||||
|
Re: Wade's Workshop
|
||||
---|---|---|---|---|
Home away from home
|
Mal
I hate to say this, but it is very obvious that the guy spraying your Rhino Lining doesn't know what he's doing. They should be no where near that rough when they're done spraying. He needs to have a talk with the Rhino Lining guy in Minneapolis, Minnesota, or with Dave Mitchell.
Posted on: 2010/4/15 11:42
|
|||
West Peterson
1930 Packard Speedster Eight Runabout (boattail) 1940 Packard 1808 w/Factory Air 1947 Chrysler Town and Country sedan 1970 Camaro RS https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?topic_id=4307&forum=10 http://aaca.org/ |
||||
|
Re: electric fuel pump to assist starting?
|
||||
---|---|---|---|---|
Forum Ambassador
|
John, This topic has been discussed on the forum several times so you might try using the search feature in the upper right hand corner. If you don't find what you need I am sure you will get plenty of advice on the topic. I have a pulse type flow through pump installed in the gas line near the gas tank to assist with those starts after the car has sat for several days. Some will argue with some justification that it is better to crank the engine over to obtain some oil pressure before starting the car after a long sit rather than use an auxiliary pump to allow less starter cranking. Here is a link to one thread on the subject on this forum. The Packard Club also has some excellent information on the installation of an electric pump in the "Tech Tips section you may want to peruse.
https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?topic_id=4411&forum=4&post_id=47921#forumpost47921 http://www.packardclub.org/
Posted on: 2010/4/15 11:10
|
|||
______________________________________________
Dave |
||||
|
electric fuel pump to assist starting?
|
||||
---|---|---|---|---|
Home away from home
|
Our 55 constellation after setting for a few days is hard to start. The carb is rebuilt as is the complete fuel system. After it starts there are no problems until the next time it is not driven for a few days.
Question what type/pressure fuel pump can be installed to assist in cold starting? Suggestions please Thank You John Miller
Posted on: 2010/4/15 10:46
|
|||
|