Check with Olsons, Port Orchrd, WA,
They have the gaskets .
I provided them with template usable original off of my 37 115c .
Larry

Thanks

Do you still need pictures of the headlight wiring routing.
The driver's left front by the steering gear box.
That wire cuts out through the splash guard to the headlight.
The right hand wires hit a set of Junction points at that same point in front of the steering gearbox. Then it traveled on the rear side of the crossmember up and out through the splash guard by the shock tower on the right hand side.
The right hand splash guard on my 37 touring had a hole drilled through it for the wire to pass through from the factory.
I know part of the front end on my car was disassembled because these three wires on the passenger side had been cut spliced and taped.

Thanks for the photo.

Great find on the information

A thought.
Jump the distributor 1 tooth counter clockwise and retime to that position.
This should move the vac adv down away from the canister,
Just doing some arm chair thinking. :)

Kev can you post a couple pictures of the hood support brackets that are in this photo.
Also any other styles that you may have. Looking for ideas for my 37.
Thanks Larry

Attach file:

---

  37 JAVPAC w open hood.jpg (154.13 KB)

Here ae three locations from the battery to rear, Ill look for the forward ones later.
I'm sure there is one between the battery and where it goes up over the frame.

As I remember as I ran the turn siginal wires there were not many attachments since it was running inside the frame rail.

Here ae three locations from the battery to rear, Ill look for the forward ones later.
I'm sure there is one between the battery and where it goes up over the frame.

As I remember as I ran the turn siginal wires there were not many attachments since it was running inside the frame rail.

Attach file:

---

  11 rear most frame clamp with tail light pig tail ____wire __ clamp.jpg (0.00 KB)


  10 past the gas tank and through rear cross member ___wire __ Clamp .jpg (0.00 KB)


  8 continuing through cross brace frame ___wire ____clamp.jpg (0.00 KB)

Well here you go.. The car is in a cold garage and I tried to catch the wiring front to rear. these are front to rear.
If you want a better shot let me know the one and I'll try to retake later
LArry
Note, The plastic loom is for the 12volt turn stop lights that were added so that people actually see what I am doing.

I'll get the front photos later LAR

Attach file:

---

  1 Generator connection.jpg (249.91 KB)


  Wires going from fire wall under the body at frame rail.jpg (350.38 KB)


  3 Wire comming from engine into frame rail.jpg (166.56 KB)


  4 Wire continuning towards battery.jpg (291.51 KB)


  5 continue behind battery .jpg (259.38 KB)


  7 entering rear cross brace .jpg (203.35 KB)


  8 continuing through cross brace frame.jpg (193.86 KB)


  8 out of frame brace and past rear shock mount .jpg (273.89 KB)


  10 past the gas tank and through rear cross member .jpg (220.61 KB)


  11 rear most frame clamp with tail light pig tail.jpg (278.06 KB)


  13 r tail light up feed .jpg (432.95 KB)


  14 rear transfer along frame behind gas tank.jpg (215.69 KB)


  15 L Taillight up connection .jpg (242.39 KB)