Sorry it's in my description it's a 41club couple.......

Ok i give i tried to take the radiator out today. I removed the six bolts (3 each side)in the engine bay and it is being held by something else it wont bundge!!!!!!!!

Did i miss bolts on the bottom???????

Hey Owen you are right after some brake cleaner and a small wire brush, it turned out to be a nut . And i was pretty lucky after reading some posts abut how hard it was to get out. The nut just loosened right up and the bulb slide right out. The one thing im not sure about now is the the length of the wire is long, the previous owner had it wire tied to the radiator support rod. Isnt that length supposed to be in the cab under the dash?????? and it looks to be about 2' to long as well.

Quote:

Thanks that saves a lot of money the studs nuts and washers are expensive little buggers........found the block pug thats exactly what i was looking for.

Now the only thing thats keeping me from pulling the head is that braided wire.....is that a temp probe and how do i get it out

Right on the bottom????, i looked on the backside (towards the engine) and there was no petcock.

How about a plug to drain the engine block???

Hey all got back from the long vacation, i am taking the head off and have a few questions.
Do you reuse the head bolts, nut and washers when reinstalling. Chevys and Fords are a no no. Not sure on Packard.

What is the hole and plastic grommet??? on the side of the head towards the rear drivers side that has a shielded wire coming out and going to the inside. And how do you get this wire out of the head.

One last question is there a plug to drain the engine block of coolant????

Pat.

Getting ready to do a wire harness. In searching the site i see Potomic mentioned a lot, but are they still open ??? i cannot find a website for them. YnZ and riwire are also mentioned and seem to be priced about the same is there one any better than the other???? on these kits are the light bulb plugs/sockets included or do the old ones need to be reused if possible?

Hello All, i went over and started Bonnie today and the water pump is squealing and and is leaking. Is there a place that rebuilds pumps or is it just as good to use a vendor?

Does anyone have/know where i can purchase a jack and tire iron for my car?????