1934 Packard Fuel Tank
|
||||
---|---|---|---|---|
Quite a regular
|
Can someone tell me the correct color for the 1934 Packard fuel tank? Should it be zinc colored or black? Thank you!
Posted on: 2020/6/1 21:59
|
|||
|
1953 Caribbean boot & top snaps
|
||||
---|---|---|---|---|
Quite a regular
|
Can anyone tell me if the '53 Caribbean top boot & top all have the same snaps at the rear of the car & the rear quarters? The 6 that were on my car on the quarters behind the 1/4 windows were lift the dot type snaps but the top had been replaced sometime during its history! If they are regular snaps are sheet metal type screws used in all locations? Thank you!!
Posted on: 2019/8/6 17:53
|
|||
|
1953 Packard Caribbean top boot bag
|
||||
---|---|---|---|---|
Quite a regular
|
Does anyone have a picture & or dimensions for a '53 Caribbean top boot bag?? From what I understand it would have been made from the vinyl used for seat trim not the leather used for the seat cushions! Any help would be greatly appreciated! Thank you!
Posted on: 2019/6/10 22:20
|
|||
|
Carpet for Caribbean
|
||||
---|---|---|---|---|
Quite a regular
|
Does anyone know of good supplier of a quality presewn carpet kit for a '53 Caribbean! I tried SMS & what a joke! Waited 5 weeks to receive it because it was on back order after I was told two weeks! Nonetheless I received the carpet & it doesn't fit & terrible quality!! Any recommendations???
Posted on: 2019/5/29 15:29
|
|||
|
Convertible top choices
|
||||
---|---|---|---|---|
Quite a regular
|
Anyone have any experience with replacement convertible top manufacturers! I'm putting one on a '53 Caribbean! I know there are several! Electron & Robbins just to name a couple! Which ones would my fellow Packard collectors recommend?
Posted on: 2019/5/28 17:29
|
|||
|
'53,'54 convertible glass adjustments
|
||||
---|---|---|---|---|
Quite a regular
|
Can anyone tell me if the rear qtr glass on a 53 convertible should be slightly higher than the door glass? I have adjusted the door & latch, the door window regulator bolts, door glass stops & rear qtr glass stops. There is a slight bevel on the rear qtr glass, so should the door glass come up even with the bevel or up to the higher part of the qtr top frame? All parts are new, cylinders, glass, hyd pump rebuilt & everything seems to be working great! If I adjust the two door glass regulator bolts the top of the door glass protrudes too high above the door when the window is down! Any advice as to something I'm missing & or pictures would be great!! Thanks
Posted on: 2019/5/11 22:34
|
|||
|
Re: 1953 Caribbean top cylinder yoke pins
|
||||
---|---|---|---|---|
Quite a regular
|
Thanks so much for the picture Don!!!!
Posted on: 2019/5/4 5:21
|
|||
|
1953 Caribbean top cylinder yoke pins
|
||||
---|---|---|---|---|
Quite a regular
|
Can anyone tell me what type pin or bolt goes through the top cylinder yoke that holds the rear arms in the yoke as mine were missing?? Would it be the same type pins that hold the side rails & other arms on the side rails with cotter pins? One picture I was looking at seemed to be a bolt but I don't know if that is correct?? Thank you!!
Posted on: 2019/5/3 22:01
|
|||
|
Re: 1951-1953 Packard bumper jack cardboard box
|
||||
---|---|---|---|---|
Quite a regular
|
Thanks Guys!! Right on answers!!! Check in the mail to him!!!
Posted on: 2019/5/1 21:04
|
|||
|