you should get with peter fitch, and get the shift lever, and parking pawl made out of metal.

Pac sw found this
Stude boot..6 bucks ebay.

Bought it.

Attach file:

---

  (118.53 KB)


  (75.96 KB)


  (72.65 KB)

could a speedo cable work to replace nylon?

that's what I have been thinking,, from your comments,

easy,

so I will see about casting, about how many if they ask?, 100?,

but going for one first, see what that cost is,

I was looking at swapping regulators, with the dorman,

I am going to set up a test board, with plywood, with a tension spring on regulator ,, this way you can watch what's going on,

h,

out at pac sw, got more info, and reg, I am thinking now to remove the bracket,

and use that gear on the motor, think I am going to put it on plywood, to get things placed, and run it,,before putting it on door,

going to take that Teflon one to see what it would cost to cast,

I saw some oil gears that might work

I looked thru the 56 parts book, they sent me,

metro might have some type of boot,

ok,

cant' find a post on it,

anyone making, or any NOS, pressure switch boots around,

might have to make these too, mean time, possibly going to use a gas pedal bellows,

gp# 3.3144 pt# 6480824

if you fly into san diego, I will pick you up in one,

when I came back from maui in 1977 my dad pick me up in his pack 12, the flight crew was like wow!, they were out side,

let, I have that,

I was hoping for a little more,

ross vent hole,

I would of put them in, but I think it can be mod, about dust getting in,

make 2 vent tubes, like the valve train vent tube,

but on the car ,,, think I will make an inspection plate with slots in it, the flywheel will blow heat out, not like the bell housing holes, but heat will get out,


and to really get into it, put air filters,, in pipes,

one of the years they did not have inspection plate,,55?,,