I cleaned the carb and am putting it back together but I am unsure were this goes. Is it a check under the accelerator pump nozzle bolt?
Thanks
John

Attach file:

---

  (462.50 KB)

Will do. Thanks
John

Thanks everyone. It doesn't seem like it was rethreaded. The old bolt wasn't super tight.
John

Thanks. I looked again. I miss read the bolt gauge.
John

I had to change my thermostat housing as it was pitted and leaking. One bolt was I think the original 3/8"-14 x 7/8 so says my bolt gauge. Which is a hard to find size. The other had a metric bolt stuck in that happened to fit.
I checked Kanter and Mxz Merrit. Where do you get these bolts?
Thanks
John

You are correct the outlet is on the wrong side. I will need to pipe the water back to the passenger side. My fab skills aren't good enough to move the outlet.
John

The Bronco radiator is listed as 29" wide. The 51-54's have a 26" wide slot for a radiator. Has anyone used a 53-56 Ford Truck Radiator in a Packard?
https://www.summitracing.com/parts/sum-384038

Thanks
John

Thanks
John

Thanks for the help and no problem.
John

Any recommendations on how to remove the cover over the accelerator pump check ball?

Thanks
John