|
Re: Late 30s Trunk Rack
|
||||
|---|---|---|---|---|
|
Just popping in
 
|
Thanks! That's exactly what I needed!
Posted on: 2014/12/31 4:11
|
|||
|
||||
|
Late 30s Trunk Rack
|
||||
|---|---|---|---|---|
|
Just popping in
|
Does anyone have a 36-39 Junior Trunk Rack that they could measure for me? Or, does anyone know the measurements of one?
I'm trying to buy one but I need to know the correct measurements so I buy the right one. Any help would be appreciated!
Posted on: 2014/12/26 12:31
|
|||
|
||||
|
Re: 30s Convertible top Molding
|
||||
|---|---|---|---|---|
|
Just popping in
|
Thanks for the pictures & sorry about the delay... with your pictures I ended up getting a foam rubber insert with adhesive on one side & sticking it in the convertible top groove so it seals with the window better...so far so good...& no water inside!
Posted on: 2014/1/27 20:29
|
|||
|
||||
|
30s Convertible top Molding
|
||||
|---|---|---|---|---|
|
Just popping in
|
I have a 37 conv 115 & there was no molding / weatherstripping on it so I bought it online, but it didnt come with directions and I can't seam to find a single picture to show how it was installed, online.
The molding is to fill the gap between the top of the window & the bottom of the top, as well as the piece that goes between the top & the top of the windshield, as seen circled in the picture below:  Does anyone have a convertible (36-39) that they wouldnt mind sending me or posting close up pictures of the rubber molding used & how its installed? Can anyone direct me to some pictures or installation directions online? Thanks
Posted on: 2013/6/5 19:28
|
|||
|
||||
