Packard Forum Index » Pre-War (1899-1942)

I am attempting to remove the front clip of my 37 Packard but cannot find a block or a place to separate the headlight harness from the main harness. Is there not a connector, it appears to be all one piece from the headlights to the dash. Also should I remove the fender bracket or leave it in place as far as removing the front clip is concerned. .also On my car the outer bolt at the fender is too long to remove allowing clearance to lift the fender off.I wonder if this is common or if someone used too long of a bolt back when it was restored in 1977?