Packard Forum Index » Post-War (1946-54)

Thanks John. My loom is fairly limp in that section. I'll use the carb clamp and tuck the horn relay wires tight so that and being over the plug wires should keep it up.

Going to be wiring in my AC module. If it works and stays will be taking advantage of the voltage and signal at the carb switch so adding another stiff woven loom with the additional wires inside should help keep it suspended.

Howard, sorry not much help here the horn had been removed.
Wes

Attach file:

---

  (128.93 KB)


  (125.40 KB)

Howard - Don't know if your car has the Electromatic Clutch - but there is a a wire clamp attached to the top screw on the Accelerator Switch . ( See Fif. 22 -page 25 of the 46-50 Service Manual.