Packard Forum Index » Post-War (1946-54)

I am rewiring my 1947 Deluxe Clipper. I removed the harness going from the passenger side headlight to the junction block by the driver's fender a couple weeks ago. I went to mount the new harness today and I could not remember how the harness got routed across the radiator. It is too short to go under the radiator. It seems like it has to go in front of the radiator above the grill or under the arched beam above the radiator, but I don't see any harness clips in those areas. I would really appreciate the help.
I am sorry I have to post such a stupid question.

Can't speak for sure on the deluxe but the custom has a bar that spans across and carries a long cable from right side to the terminal block on left side. Bar is 22 inches long pointed end to estimated point. Anything like that on yours?

Attach file:

---

  (20.61 KB)


  (11.51 KB)

Thank you for the reply. I don't see a bar like that. I tried to attach pictures of my front.

Attach file:

---

  (26.20 KB)


  (24.70 KB)

I now see how it is done. I removed a chrome piece in front of the radiator right where your bar was, and I can see the clips that hold the harness. Thank you for your help.

Attach file:

---

  (19.43 KB)


  (19.54 KB)