CRANKSHAFT HONING MACHINE - 2777-A : Misc Packard Photos : Photo Archive

Main : Misc Packard Photos CRANKSHAFT HONING MACHINE - 2777-A

[< Previous 278 279 280 281 282 283 284 Next >]

CRANKSHAFT HONING MACHINE - 2777-A Popular

BigKev

Misc Packard Photos

07/23/2018 10:21

1187

0.00 (0 votes)

Rate this Image

The usual method of finishing a crankshaft bearing is to use a hand lap while the
shaft is rotating in a lathe. In the Packard factory the idea illustrated in this
picture was originated to hone to size and to correct out-of-roundness and taper
on Packard crankshafts - again to insure and assure your customer's investment.
Packard has about $60,000 invested in a sufficient quantity of these machines to
keep up with present-day production. Time saved by machine over old hand method
approximately 40 minutes per unit.

Picture courtesy of Roscoe Stelford

[< Previous 278 279 280 281 282 283 284 Next >]

The comments are owned by the author. We aren't responsible for their content.

myAlbum-P 3.09 by XOOPS

	';
Hello and welcome to Packard Motor Car Information! If you're new here, please register for a free account.