Photo Archive - Packard Motor Car Information

Main : Misc Packard Photos

»» Total:12874

Sort by: Title (

) Date (

) Rating (

) Popularity (

)
Photos currently sorted by: Popularity (Most to Least Hits)

Photo No. 291-300 (out of 342 photos hit)

« 1 ... 21 22 23 24 25 26 27 28 29 (30) 31 32 33 34 35 »

Packard Service Vehicle 12 Popular

BigKev

Misc Packard Photos

05/02/2016 9:35

850

0.00 (0 votes)

Rate this Image

Vehicle used by a Dealer for delivering parts or for other service operations.

From the collection of Fred and Carol Mauck

Rear Axle End Play Measurement Popular

kunzea

Misc Packard Photos

04/11/2022 12:40

845

0.00 (0 votes)

Rate this Image

1951 2498 Ultramatic

Packard Service Vehicle 18 Popular

BigKev

Misc Packard Photos

05/02/2016 9:35

840

0.00 (0 votes)

Rate this Image

Vehicle used by a Dealer for delivering parts or for other service operations.

From the collection of Fred and Carol Mauck

Packard Service Vehicle 7 Popular

BigKev

Misc Packard Photos

05/02/2016 9:35

838

0.00 (0 votes)

Rate this Image

Vehicle used by a Dealer for delivering parts or for other service operations.

From the collection of Fred and Carol Mauck

UnknownModel Popular

BigKev

Misc Packard Photos

04/27/2016 19:31

829

0.00 (0 votes)

Rate this Image

From the collection of Fred and Carol Mauck

Packard Service Vehicle 8 Popular

BigKev

Misc Packard Photos

05/02/2016 9:35

827

0.00 (0 votes)

Rate this Image

Vehicle used by a Dealer for delivering parts or for other service operations.

From the collection of Fred and Carol Mauck

MOTOR TESTING DIVISION - 2045-A Popular

BigKev

Misc Packard Photos

07/23/2018 10:09

823

0.00 (0 votes)

Rate this Image

In this department the motors, 82 at a time, are limbered up, being driven by an
electric motor for a minimum of 9 hours. They are then placed on a dynamometer
rack where they, in turn, drive a motor carrying an electrical resistance. Here
the horsepower, compression of each cylinder and general perfection of the motor
are determined. The valves, oil pump, carburetor, fan belt, spark plugs, distributer,
etc, are adjusted. Then, the motor is again torn down when a final
inspection and oil pressure bearing tests are made. After re-assembling, the
unit is ready for the frame assembly line.

Picture courtesy of Roscoe Stelford