Quote:
Phils38cpe wrote:
If I'm not mistaking there are 4 screws at the base of the door for the hinges.
If the same as a 21st series, that is correct. Also 4 screws (2 on each side) holding the hinge to the sides of the opening. Unfortunately, I don't see any way to access any of the screws with the box in position.
You mentioned you had used lock picks and got the lock to turn open. After doing that, is the entire handle still unable to turn the 90 degrees to move the mechanism? If lock cylinder turns, but handle still won't open the door something must be stuck or damaged.
If the handle won't turn then it may come down to sacrificing the cardboard box. If like most others of that age, it's in fairly poor condition inside and could probably stand replacement anyway. Once the box is out of the way, instead of hinges, a single screw on the latch will let the locking tab come off and door will open.
If you do sacrifice the box, new ones are available at a couple of places. Here is one.
glovebox This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=103991