Re: 37 120 coupe convertible door handles and wipers

Posted by Dave Munger On 2013/2/15 1:33:29
RVSLS,
The wiper motor is a bit of a job . . . it helps if You are about 20 years old & very agile.

There are two very small ( about 4-40 screws with nuts that hold the motor in place ), a couple of vacumn lines and the control cable ( switch ) which mounts through the bottom part of instrument panel. Also the arms to the ( drive units) transmissions, be sure to mark the arms L & R , front,back. Lots of wire to work around & the vent handle maybe in way.

I had the floor boards & transmission out of Packard & on ramps, and it was quite a job but I'm over seventy and kind of slow.

Take your time, be patient it can be done.

Dave

This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=117724