Re: 1930 shifter missing part
Posted by Thomas Wilcox On 2013/3/25 13:25:32
Todd,
You are looking for the shifter locating ring, pictured below. Measurements on mine are:
Thickness: 0.16
OD: 2.12
ID : 1.56
Gap width: 0.22
The tab on mine, as you can see, is very worn. It should just fit into the slot on the shifter.
You may want to give John Ulrich a call and see if he has one.
Cheers,
Tom
Attach file:
(36.06 KB)
You are looking for the shifter locating ring, pictured below. Measurements on mine are:
Thickness: 0.16
OD: 2.12
ID : 1.56
Gap width: 0.22
The tab on mine, as you can see, is very worn. It should just fit into the slot on the shifter.
You may want to give John Ulrich a call and see if he has one.
Cheers,
Tom
Attach file:
(36.06 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=119812