Re: 1928 rear drums
Posted by Thomas Wilcox On 2013/3/31 9:55:51
I had a local machine shop make me a puller like DavidM's for the 30. About $90, but I don't have to worry about screwing up the finish on wheels. I took them the aluminum hubcap to get the hub thread pitch and diameter.
Unfortunately, I cannot seem to find a photo of the puller. Essentially it is round stock, machined to fit the hub on one end and threaded for 3/4" all thread on the other. The end of the all thread that goes to the axle shaft is machined with a dimple to self center on the shaft. The other end has a 1" nut welded to it.
It works very well.
Cheers,
Tom
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=120244