Re: Pedals

Posted by HH56 On 2013/6/20 8:34:30

It appears they are the same seal as later cars. As O_D mentions, they go below the floor.

You remove the single bolt holding both pedal upper foot pads to the vertical arm sections so there is just the pedal arm remaining topside. Pull back the carpet so the floor plate is exposed and remove the 4 or 5 screws holding the plate to the body. Slide plate up over the arms and off. The new pad slides down over the arm with the narrow end going first. It sort of rests on a small protrusion at the end of the vertical arm. When the floor plate is reinstalled the wide flat area will contact it and seal the air out.

It would be a good idea to clean the arm and spray it and the new seals with some silicone spray before sliding the seals down the arm.