Re: Steering center pin
Posted by Jake Powel On 2013/7/13 13:37:40
I had my center pin replaced by a frame shop last fall. This was on a 1937 115C (6 cyl). The shop used a torch to cut the rivets fastening the plate on the underside. Then they were able to access the steering and replace the pin without raising the engine. They replaced the fasteners with stainless steel bolts. If you would like a photo of the result, contact me at
jake_powel@comcast.net
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=127237