Stromberg EE-14 Carburettor

Posted by dennis Nielsen On 2013/7/24 11:25:55

Hello All. I have finally mastered the workings of the EE-14 carburettor and its choke operating thermostat. The carburettor that I got from Flackmaster had the middle section without the passage to accommodate the link between the choke- piston and the choke butterfly as well as the link itself. I thus had to drill the passage[ This middle section probably came from an EE-16] and make a link. I soon discovered that the length of this link is of critical importance, but fortunately had made it so that it could be adjusted within narrow limits. If it too long then once the engine is hot the choke-piston's position interferes with the idling mixture strength. If too short, then the choke butterfly does not open fully and this leads to a rich mixture overall. Now that this is all correct the engine runs sweetly.
I have also made a small number of the choke thermostats.These are a copy of an original with all new materials. Should any member be interested in this item, please contact me.
Regards.