king pi bushings too long
Posted by packardgary On 2013/8/13 9:46:20
Hi all,
We replaced the king pin bearings with
bushings from Kanter. The bushings are
too long for the grease cap to fit on
the end. We've already had the bushings
sized and installed at a machine shop.
I'm wondering if we're overlooking something,
or we just need to remove the bushings, cut
them off, and reinstall them. Your experience
and knowledge is greatly appreciated.
By the way, we have a 1941 110.
Thanks in advance,
packardgary
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=129178