Re: need a close up photo of a 39 120 running board

Posted by David Grubbs On 2013/12/13 21:59:01

Took the passenger side running board off this afternoon, and spent a few dusty hours with a wire wheel. I took some of the Quiksteel epoxy, the kind that you cut a chunk off and knead it until it's mixed. I made up some small batches and pressed them into the old vulcanizing holes, and smoothed them off on the top. After drying for a hour or so, I sanded them down in a 6x10 inch area and sprayed the board with the DipIt spray. So far, it looks good. Not like a brand new running board, but much better than a bondo mess and the pattern is correct. I should finish it up in a few days and will post photos.