Re: Stalling Problem

Posted by Chad G On 2014/1/20 11:01:00

Howard,

When I read your reply about the OD circuit, it dawned on me that I hadn't engaged the OD (pushed in the dash control) until after the 1st intersection in my neighborhood. I had it engaged between the 1st and 2nd intersection, just prior to it stalling.

When I get home from work (after stopping for starting fluid, and a spark tester) I'll go for a drive around my 'hood without OD engaged. That should help determine if I need to focus on the OD circuit or back onto fuel/ignition.

If it stalls, then I will test the spark, and test with starting fluid.

Thanks Again,
Chad

I'm not sure if this is relevant to the currewnt situation, but thought I should post it just in case. One other thing I just remembered is that after the carb rebuild, and idling to warm up I put a vacuum gauge on the main vacuum line, and it showed a steady 20in at idle.