Re: Tie Rods and Torque Arms

Posted by RichK On 2014/4/19 20:43:58

I was kind of done for the day, but I wanted to better simulate the top out rubber. To do that I place a small chunk of 2x4 where the top out bushing would be. I now barely rub, and I mean barely. Did the other side with the same results.

I figure with the engine and body installed, I'll be good. I'll post a photo in a bit, as well as keep folks posted when I get a real load on the springs.


I indeed checked my tie rods... same height as old when installed.

John & Flack - thanks for posting!


Rich