1937 120 Center Steering Linkage

Posted by packick On 2014/5/9 10:39:44

This topic may have been discussed before in the Forum but I could not find a discussion relating to it.

I have a 1937 120 and need to replace the center steering linkage bearings and pin located under the radiator/engine pully. What is the best way to get at the bearings and pin to remove the old ones and insert the new ones? Does the whole front-end of the car have to come off? Can I just remove the hood, radiator and engine pully?

I would appreciate any help from someone who's been there, done that.

Thanks.