I didn't look at the Restoration Supply pages, but they should be knurled and nickel-plated thumb screws, smaller than the ones used in the earlier series. Wire ends are brass eyelets, both ends. Wires should be rubber and covered in gray lacquered cloth (see purchasing spec. attached). Not sure my thumb screws are 100% correct but see the pix. I have a pix somewhere of the eyelet, will post if I can find it but it's about the same OD as the lower flange on the thumb screw, that is, none of it protrudes beyond the thumb screw.
Attach file:
(179.16 KB)
(32.48 KB)
(67.87 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=170886