Re: head gasket problems with 1935 eight

Posted by Marty or Marston On 2016/2/29 17:33:58

I think I would remove the head and examine the area (head * block) for any cracks. I would clean and wipe down around the areas where the leak is then coat with a penetrating dye to look for cracks. If none are found, then I would reinstall the head with a new gasket. If you still have the old gasket, I would compare the new vs. the old.

Good luck and hopefully your problem is just a bad gasket. You might also want to check the head for flatness.