Re: 1937 120 water pump problem

Posted by R Howe On 2016/11/15 21:44:17

Thanks so much for the information, Fred. Since I do see about 1/32" of the shaft at the back of the impeller, then I am assuming that when it was rebuilt, the shaft was not installed according to the proper tolerances. What I think I will do is take it to the machine shop here and see if they can get the shaft flush with the impeller as you say it should be. If they can, then I'll see if that solves the problem. I'll let you know what happens after that. Again, thanks for the help.