Re: 1930 7th series standard eight Motor Oil Pump Cleaning

Posted by 120p400 On 2008/12/27 12:28:34

Just for a follow-up. If you need some space for shaft or protrusion, you can make up steel vise block as shown. the blocks can be 2 piece, no need to mill something out, but you do need a top lip on each block to keep it from dropping out as you adjust the distance. We all have a supply of dull drill bits that can be matched for size to use for these tasks. i hope this will help.
Oh yes, a groove cut in the clamping face of each block to keep the bit in place (with a Dremel or cutoff tool) is needed as well.
Craig

Attach file:

---

  (15.15 KB)