Re: 1930 7th series standard eight Motor Oil Pump Cleaning

Posted by Thomas Wilcox On 2008/12/29 12:36:06
Quote:

Owen_Dyneto wrote:
Tom, you were inquiring about the threaded shaft that protrudes from your pump base once the screen retainer shield was removed. I checked my 33 pump (same pump); it's simply the shaft for the driven gear; it's not a "fitting", just a threaded stub shaft. I didn't fully diassemble but I think it's pressed in and shouldn't rotate.


The stub shaft rotates if you rotate the cap on the top, using your spanner wrench. Perhaps the entire driven gear assembly is pressed in? And what is the purpose of the spanner cap?

Thanks,

Tom

This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=18939