Re: Ignition coil 1940 160
Posted by HH56 On 2017/10/10 10:15:24
Which coil setup do you have? Does the cup mount with bent over tabs or does it twist on?
If someone has an old junk twist on type coil I would be interested in acquiring one to see if something could be made to hold and mount a modern coil to the block with a cup support along the lines I did with the firewall mount. The tab type would be easy as it would just be a version of the firewall mount already figured out but without the flat mounting plate. Holding the twist on type cup is a different challenge but maybe just a different end treatment would do the trick.
Here is the Clipper version of the tab type coil and the two different style cups I am aware of. Except for the way the armored cable exits the cup, unless there is a different diameter on conventional body coils I expect the cups would be similar.
Attach file:
(116.94 KB)
(132.11 KB)
If someone has an old junk twist on type coil I would be interested in acquiring one to see if something could be made to hold and mount a modern coil to the block with a cup support along the lines I did with the firewall mount. The tab type would be easy as it would just be a version of the firewall mount already figured out but without the flat mounting plate. Holding the twist on type cup is a different challenge but maybe just a different end treatment would do the trick.
Here is the Clipper version of the tab type coil and the two different style cups I am aware of. Except for the way the armored cable exits the cup, unless there is a different diameter on conventional body coils I expect the cups would be similar.
Attach file:
(116.94 KB)
(132.11 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=196461