Re: crank shaft counterweight removal
Posted by BDeB On 2017/12/1 3:25:09
Here is what I did to remove the counterweights on a 22nd Series 356 engine using a splined screw extractor.
Drilled the bolts to the size specified for the extractor and drove the extractor in with a hammer.
Used a beam type torque wrench to gradually apply forceuntil the bolt broke loose then turned it out. The hex on the extractor was only 5/16" so had to use an impact socket after breaking a standard one.
Attach file:
(179.75 KB)
(160.82 KB)
(186.93 KB)
(223.35 KB)
Drilled the bolts to the size specified for the extractor and drove the extractor in with a hammer.
Used a beam type torque wrench to gradually apply forceuntil the bolt broke loose then turned it out. The hex on the extractor was only 5/16" so had to use an impact socket after breaking a standard one.
Attach file:
(179.75 KB)
(160.82 KB)
(186.93 KB)
(223.35 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=197983