Re: Steering Wheel Light Switch on a '32 901

Posted by Marty or Marston On 2018/3/30 17:17:30

You're right about the felt. The horn button is held on by 4 machine screws. One needs to loosen the nut at the bottom on the column and pull the assembly up. It appears that if I put enough packing in the assembly at the bottom of the steering box tha I will be able to tighten the nut enough to prevent the shafts from turning. Inspecting everything I did not find any areas that would be the cause of my problem, other than the packing was worn out and needed to be replace with the nut being taken down real snug.

I will be trying this out tomorrow and let everyone know.