Re: Packing rear axle bearings on a 39
Posted by jwblazek On 2019/3/1 14:14:12
Hi James
We have used Kanter for over 30 years and appreciate your support and knowledge
There were two different sized pins in the kit supplied, #9 & # 10. I could not read the number on the old pins as they are corroded. Here is a photo for comparison
The anti rattle springs were badly corroded on this 80 year old car and one was broken in half. Fortuneately, I was able to find very close ones at a local auto store
The springs that I think should have been included is the one from the secondary shoe to the small spring tie down on the backing plate, the smaller black spring at about the 3:00 postion in the photo. I reluctantly used the old pins after cleaning them up on a wire wheel
Attach file:
(97.44 KB)
(83.49 KB)
We have used Kanter for over 30 years and appreciate your support and knowledge
There were two different sized pins in the kit supplied, #9 & # 10. I could not read the number on the old pins as they are corroded. Here is a photo for comparison
The anti rattle springs were badly corroded on this 80 year old car and one was broken in half. Fortuneately, I was able to find very close ones at a local auto store
The springs that I think should have been included is the one from the secondary shoe to the small spring tie down on the backing plate, the smaller black spring at about the 3:00 postion in the photo. I reluctantly used the old pins after cleaning them up on a wire wheel
Attach file:
(97.44 KB)
(83.49 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=209714