Re: Engine R&R...
Posted by Packard Newbie On 2019/3/23 21:23:59
Hard at it today... got a lot done and also fabricated my own clutch linkage rod out of 5/16" rod stock. Bent and drilled to match original - hard to tell the two apart, except for the extreme wear on the old one!! Couple of pics... Dave (Owen Dyneto) note the new fuel pump as per your good suggestion!!
A few more goes at it and I should be ready to put the front end clip back on.
Attach file:
(239.91 KB) (292.41 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=210425