Re: Routing of wiring harness, oil pressure line, temperature line in '37 120C

Posted by Packard Newbie On 2019/8/21 18:20:02

Hi RHowe, Re your routing question(s) I am not sure if your '37 is the same as 39/41, but I have attached a pic that was posted a while back by a '41 owner that shows the water/oil lines going through the firewall. The setup is exactly the same on my '39. Also, there is a grommet available that goes inside the rectangular 'frame' on the hole and I BELIEVE the wiring harness goes through the large hole in it, to the inside of the firewall. At any rate, you can check your car against the photo and see if yours is the same/similar. If yours is missing, one could easily make the gasket out of 1/4" closed cell foam or they can be ordered from Steele Rubber Products for a nominal fee. Hope this helps, Good luck. Chris.

Attach file:

---

  (34.22 KB)


  (5.73 KB)