I would think the 12 should be the same. Since they are L blocks.
This is what I made.
Had to use b7 all thread ..the all thread you can use that to put them in also
I made the punch from brass just in case.
The machine shop drive them in. I had to pull them up to get clusters in.
New valve guides on the taper are not as thick as original ones.
Attach file:
(210.39 KB) (218.96 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=217319