Re: Axle Rato = coded - stamped?
Posted by Ozstatman On 2009/3/16 13:59:30
Quote:
John,
It is 11-48 which equates to 4.36:1 and that matched the ratio on the housing.
And Dave,
Of course, I didn't find either set of stamped numbers until after I'd counted the teeth on the ring and pinion! This for a number of reasons. Didn't know they were there, the center section was covered in hardened gunk and the ring markings were assumed as part numbers until I looked closely at them just after I'd finished the counting trick.
johnoder wrote: I.E., if the above photo is showing 11-43, that equates to 3.91:1 John Oder
John,
It is 11-48 which equates to 4.36:1 and that matched the ratio on the housing.
And Dave,
Of course, I didn't find either set of stamped numbers until after I'd counted the teeth on the ring and pinion! This for a number of reasons. Didn't know they were there, the center section was covered in hardened gunk and the ring markings were assumed as part numbers until I looked closely at them just after I'd finished the counting trick.
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=24132