Re: How I removed running board rubber

Posted by flackmaster On 2022/7/10 21:44:52

sorry if my comment gets us too far offtrack.
Once upon a time when I was less patient, I grabbed the air chisel (dullest one from under the workbench) and a really hard block of wood and went at the sides of a cast iron cylinder head that was going to come off whether it wanted to or not. Based on liberal amounts of "solvents" I could tell at least which studs were free. I think I recall a few wooden wedges being asked to help, but I believe it was the percussion that ultimately released the bond. Either that or the block saw me eyeing a sledgehammer and a torch....