I had my saw in hand ready to start sawing but the talk of bronze bushings has me stumped. The rubber on mine were so bad that I had no problems removing the sleeve. I had no luck with the "Big socket, small pipe, big bolt" in the photo trying to press out the steel outer sleeve. The new bushings arrived with a steel inner sleeve. Where is there bronze that needs to be honed? Bob
Attach file:
IMG_2111.jpeg (139.73 KB)
IMG_2112.jpeg (150.62 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=259964