Re: Replacing Cowl Vent Gasket
Posted by Bob J On 2023/10/4 13:37:08
I have a 37 but I suspect it is a similar assembly method. The gasket went in quite easily with the vent off.
Mine has two #10 screws/washer/nuts holding the vent to the pivot arm under the dash. (Not a great place to reach and could surely do with cage nuts instead but it is only two, thank you Packard.)
I have attached two images, they are heavily cropped from images of other subjects so are a bit grainy and small but show the two holes in the vent plate and the one bolt/nut/washer fastener under the dash after assembly.
Attach file:
Vent.JPG (33.92 KB)
Vent fastener.JPG (116.14 KB)
Mine has two #10 screws/washer/nuts holding the vent to the pivot arm under the dash. (Not a great place to reach and could surely do with cage nuts instead but it is only two, thank you Packard.)
I have attached two images, they are heavily cropped from images of other subjects so are a bit grainy and small but show the two holes in the vent plate and the one bolt/nut/washer fastener under the dash after assembly.
Attach file:
Vent.JPG (33.92 KB) Vent fastener.JPG (116.14 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=262419