Re: Rebuilding a sylphon thermostat

Posted by DM37 On 2024/2/25 8:17:48

"Dell"

A few follow up questions:

1) Presuming the bellows cavity was empty. How much Methyl alcohol volume did you inject through the pinhole?
2) When you tested it thermally, from room temperature to peak 195 deg F (or whatever your peak test temp was), what was the total measured stroke on your units center shaft? (factory manual says 9/16", or 0.5625")
3) At which temperature did you notice the stroke beginning to change perceptibly/dramatically

Many Thanks, Dan