Another question that time has left without remembering. Using copper kote on gasket as I have done many times, and using again, anything I need to know about? Can I spray it on and leave it for a period of time, or spray on when ready to install?
See the photos, the old gasket come off this side up and from what I can see both sides look the same? But might be covered in copper kote? The new gasket has two sides which side should be toward the block,or down, if it makes a difference?
Attach file:
packard 1.jpg (167.80 KB) packard 2.jpg (147.64 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=271012