Re: Where can you get floor pans and other sheet metal repair panels
Posted by Bob J On 2024/5/10 10:39:18
In looking at the image it is quite different, at least to my 37 120, and I believe the body is the same between the 115 and 120 from the cowl back.
It is an assembly of wood and metal. You will need a metal toe board that fastens to the cowl's inside rail/gusset features and a wooden floor board that sits on the rear edges of the toe board and inside the rails of the metal floor pan that goes under the driver's seat. I also added gussets to the wooden frame rail piece at the left and right of the floor boards too so that was extra sturdy below my feet.
I have attached a few images to help illustrate:
Bob J.
Attach file:
Floor pan seat for floor board.JPG (1,079.46 KB)
inner cowl painted.JPG (2,808.30 KB)
Cowl Fit.JPG (2,545.59 KB)
It is an assembly of wood and metal. You will need a metal toe board that fastens to the cowl's inside rail/gusset features and a wooden floor board that sits on the rear edges of the toe board and inside the rails of the metal floor pan that goes under the driver's seat. I also added gussets to the wooden frame rail piece at the left and right of the floor boards too so that was extra sturdy below my feet.
I have attached a few images to help illustrate:
Bob J.
Attach file:
Floor pan seat for floor board.JPG (1,079.46 KB)
inner cowl painted.JPG (2,808.30 KB)
Cowl Fit.JPG (2,545.59 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=271381