Re: 34 Starter motor Gear problem

Posted by Owen_Dyneto On 2011/4/9 8:06:10

If it clicked but didn't spin, several possibilities.

(1) The solenoid contact plates are corroded. You can disassemble unit and just reverse the large brass or copper contact discs. Easy fix- like new.

(2) Perhaps more likely a dirty armature, worn brushes, or (worst case) a dead segment on the armature. The latter usually requires a new armature.

Remove the brush cover and check the condition of the armature. Try cleaning it and replace the brushes if needed. If that doesn't do it, remove the armature and check each segment of the commutator for a short to ground (the shaft).