Re: Cylinder taper on 1930 standard 8
Posted by Thomas Wilcox On 2008/5/15 14:18:26
Owen,
Thanks for the info.
I realize the fit will not be perfect. I was just wondering if that was enough wear to cause major compression loss (given that I will have new rings).
I have sent an e-mail to a couple of vendors, but have not heard anything back. I was just wondering if anyone out there has a preferred/known vendor.
Thanks again for the help.
Regards,
Tom
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=7477