Re: '35 Standard 8 Oiling issue

Posted by 32model901 On 2011/7/2 15:27:33

IMHO,

In addition to proper gasket/ sealer selection always check the flatness of the two matting surfaces that clamp against the gasket.

The best gasket in the world is useless if the matting surfaces are not flat.

I the surfaces (not including cylinder heads) are not flat within .001 to .005" I'll take a skim cut to even things up.

When setting the oil pressure I usually use a quality bourbon tube mechanical or digital gauge, accurate to + - 1 to 5%, instead of relying on the dash gauge.

This way you know the pressure is set correctly and you check the dash gauge for accuracy at the same time.

Regards,

Dave