Re: Removing Steering Column--1941 Packard One-Twenty
Posted by JD in KC On 2011/9/26 9:46:31
Quote:
Found a picture in the 46-50 Shop Manual. The illustration shows tool J-2572. The KM Tools manual shows J-2572 as being the Packard-specific tool for all models 1939-1950. Looks like the universal tool would work fine.
Attach file:
(24.16 KB)
(21.83 KB)
HH56 wrote:
The 47 manual says to use a pitman arm puller, and cautions that damage may occur if trying to remove without one. Will go out on a limb and say the 41 probably needs one too. The tool number mentioned for the 47 version is different than 55 version but suspect the principal is the same. Unfortunately no picture of the 47 tool. This picture is of a modern type approximating the 55 Packard version...
Found a picture in the 46-50 Shop Manual. The illustration shows tool J-2572. The KM Tools manual shows J-2572 as being the Packard-specific tool for all models 1939-1950. Looks like the universal tool would work fine.
Attach file:
(24.16 KB)
(21.83 KB)This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=86807