Re: Sump plugs
Posted by Ken Sadler On 2011/9/27 4:51:40
Thanks again chaps.
I have ordered the socket wrench adaptor mentioned by Rusty.
Plan A is to grind the chamfer edge off the new 3/4 square socket to get a good tight fit and then apply an open end 1" spanner with an extension bar. I can hold the socket firmly against the plug with a bottle jack underneath. (never like my fingers too close when applying 100ft lb of torque!!
Plan B is to put the old filter back on and take it down to my local garage. They have pneumatic wrenches and if they use 3/4" drives, they can put it up on the lift and apply the gun straight to it. The run to the shop will also warm the oil in the pan.
I am ordering a new plug from the supplier suggested by Owen Dynetto.
I'll post pictures of the procedure (an possible injuries!!) shortly!!
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=86869