Re: Help with Heat Riser spring direction
Posted by BDeB On 2012/3/9 0:12:18
Here are some photos of a 22nd Series Custom 8 manifold showing the thermostat and counterweight sides.
It looks like you may not have the right anti-rattle spring on the counterweight side. The proper spring has an extended loop on the lower end that slides down on the slotted pin as the counterweight rotates so that it does not apply any tension until the weight is at its lowest position.
Brian
Attach file:
(99.24 KB)
(91.39 KB)
(108.67 KB)
It looks like you may not have the right anti-rattle spring on the counterweight side. The proper spring has an extended loop on the lower end that slides down on the slotted pin as the counterweight rotates so that it does not apply any tension until the weight is at its lowest position.
Brian
Attach file:
(99.24 KB)
(91.39 KB)
(108.67 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=96393