Re: Gear Vendors OD Unit Installation
Posted by 32model901 On 2015/8/3 17:51:29
Bilbo,
Thank you, I appreciate the comment.
Tech support at Gear Vendors, at least the people I talked to were very helpful in giving general guidance and instruction.
They also have a few frame mounting plates for Packard's that work with their units. These are not listed on their site, you have to call and talk with tech support to find out if they have one for your year.
Some additional custom installations.http://www.gearvendors.com/custom.html
Spicer has an excellent tech manual on proper drive shaft installation, I've attached a copy.
Drive shaft phasing, angles, alignment, and of course balance are key, pay close attention to these and you'll avoid a lot of headaches.
Dave
Attach file:
Size: 367.39 KB; Hits: 41
Thank you, I appreciate the comment.
Tech support at Gear Vendors, at least the people I talked to were very helpful in giving general guidance and instruction.
They also have a few frame mounting plates for Packard's that work with their units. These are not listed on their site, you have to call and talk with tech support to find out if they have one for your year.
Some additional custom installations.http://www.gearvendors.com/custom.html
Spicer has an excellent tech manual on proper drive shaft installation, I've attached a copy.
Drive shaft phasing, angles, alignment, and of course balance are key, pay close attention to these and you'll avoid a lot of headaches.
Dave
Attach file:
Size: 367.39 KB; Hits: 41This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=164914